The IC695ALG626 is an analog input module that offers 16 single-ended and 8 differential input channels. The module features HART version 5.0 communication capability on each channel. It has four internal HART modems. In single ended mode, four single ended channels are multiplexed into each HART modem and in differential mode, two differential channels are multiplexed into each HART modem. The analog input channels can be set up for two possible ranges. The voltage range can be +/-10 Volts, 0 to 10 Volts, +/-5 Volts, 1 to 5 Volts, and the current ranges can be zero (0) to 20 milliamperes, 4 to 20 milliamperes, and +/- 20 milliamperes. The channels which are used for HART communication must be configured for the 4 to 20 milliampere range of current.

This IC695ALG626 non-isolated differential analog voltage/current input module is fully software configurable with complete auto-calibration. No jumpers for the module setup are needed. On-board error checking is also supported in this analog module with accurate open circuit detection for all ranges of voltage and 4 to 20 milliampere current input range. Configurable scaling and warnings for high and low range detection are also supported in the module. The module offers module fault reporting and diagnostic point fault contacts in the logic program. Auto calibration at startup is supported with terminal block insertion or removal detection. Flash memory is also available for future upgrades. The input module can be used with Box style, extended box style, Spring style, and extended spring style terminal blocks. The extended terminal blocks support extra shroud depth for shielded wiring, but terminal blocks must be ordered separately.

The GE Fanuc IC695ALG626 is a type of input analog module with support for 16/8 channels. Unlike other similar modules, it comes with support for many advanced features such as the differential, voltage/current, non-isolated, and HART rating. The current rating on this module is 4-20 milliamperes, 0-20 milliamperes, and +/-20 milliamperes. There is a single slot on this analog module. The internal power rating on this module is 5 Volts: 450 milliamperes, and 3.3 Volts: 600 milliamperes. 

The GE Fanuc IC695ALG626 input analog module comes with an input current rating of current: 4 to 20 milliamperes, 0 to 20 milliamperes, and ±20 milliamperes. The maximum power dissipation rate on this module is 4.50 watts. In voltage mode, the GE Fanuc IC695ALG626 Analog Input Module has no thermal derating. The resolution on this module is 24-bit ADC. It also comes with support for Integer resolution rating, and floating-point. It comes with support for the following filter options – 12 Hertz, 40 Hertz, 500 Hertz, 200 Hertz, 16 Hertz, and 8 Hertz. This advanced analog module performs auto-calibration during power-up. HART version 5.0 is supported by this analog module. 

The current rating of the GE Fanuc IC695ALG626 Analog Input Module is 249 ± 1%. 1 second is the maximum Open Circuit Detection time. The overvoltage rating on this module is ±60 Volts Direct Current continuous, maximum. This analog input module comes with 100 kilowatts of input impedance. In Fahrenheit, the maximum operating temperature for this module is 185 degrees. It requires no jumpers for software configuration.