The MPL-B430P-MK72AA has a radial load force rating of 49 kg (108 lb). The axial load force rating with a maximum radial load is 19 kg (42 lb), while the axial load force rating with zero radial load is measured at 25 kg (55 lb). A shaft key and shaft seal can later be installed on the MPL-B430P-MK72AA if so desired. A shaft seal is used in order to prevent dust particles and moisture from entering the motor bearings. Shaft seals are subject to wear and require periodic inspection and replacement. Replacement is recommended every three months and should not exceed every 12 months, depending on use. Operators should avoid using third-party seal for the motor, as they are not approved. The shaft seal kit approved for use with the MPL-B430P-MK72AA is MPL-SSN-A4B4. Motor cables can also be installed later on the motor. Factory manufactured feedback and power cables can be paired with the motor and provide the sealing that is needed to achieve environmental ratings and shield termination. With the multi-turn encoder installed on this servo motor, high-resolution feedback can be provided within 4096 turns. The MPL-B430P-MK72AA, along with other MP series motors with high resolution encoders, are available to be used as a component of the Kinetix safe-off feature. This motor also features MP series standard smart motor technology. This helps the on-board memory retain motor identity. Smart motor technology also lets the communication link automatically report identity to the system on startup, which creates a reduced commissioning time. The operating temperature range of the motor is 0-40 degrees Celsius (32-104 degrees Fahrenheit), while the storage temperatures range is -30-70 degrees Celsius (-22-158 degrees Fahrenheit).

Part Number MPL-B430P-MK72AA is a low inertia motor produced and manufactured by Allen-Bradley. This device's rated output is two-point-two (2.2) kilowatts (kW) with a speed rating of five thousand revolutions per minute (5000 rpm). The MPL-B430P-MK72AA has a stall torque of six-point-fifty-five (6.55) Nm (58 pounds to an inch) when continuous. At its peak, the stall torque of this product maxes out at nineteen-point-eight (19.8) Nm, or 175 (one hundred and seventy-five) pounds to an inch. Additionally, the stall current of this device when continuous is nine-point-two (9.2) amperes (amps). The peak stall current of this servo motor caps out at 32.0 amperes. The rotor inertia of the MPL-B430P-MK72AA is 0.00038 kg-m² (0.0033 lb-in.-s²). For this motor, the temperature range recommended for operation lies between 0 and 40 °C, or 32 to104 °F. 

The Allen-Bradley MPL-B430P-MK72AA is a high-output motor that is also brushless. Due to its innovative design characteristics, such as a reduce motor size, this part is able to deliver significantly higher torque. When comparing this unit to other similar devices that may be more conventional, the MPL-B430P-MK72AA can yield up to 40% higher torque. The frame size of this Allen-Bradley product is a size 4, which, when measured out, is 115 (one hundred and fifteen) millimeters (mm). Additionally, this product has a 3.0 (three) inch stack length. This product is classified as a 460V (four hundred and sixty volt) motor. Also, to provide a quicker acceleration for the motor, the Allen-Bradley MPL-B430P-MK72AA is equipped with high-energy rare-earth magnets. This servo motor has On-board memory to help retain the motor's identity.