The Rockwell 2711C-T6C is an industrial panel that is featured in the PanelView Component models. The maximum clash that the system can withstand is 15 g in running conditions and 30 g while the system is off. The device grants the use of a memory card to load runtime applications. PanelView Component DesignStation is a programming environment that should be exploited to develop HMI applications for the system. The power dissipated by the panel should be 9.4 watt. The operator terminal must not stand oscillations stronger than 2 g at 500 hertz. The designer could easily connect other devices (e.g: a PLC) to the HMI exploiting its Ethernet slot. The panel has a 115 millimeters wide and 86 millimeters tall color transmissive CSTN passive matrix screen. The environment temperature in the surroundings the operator terminal must remain in the following range: 32… 122 degrees Fahrenheit while the operator terminal is running and must remain between -25 and 70 degrees Celsius when the device is in storage conditions. An access to should be designed in order to manage to deal with troubleshooting, maintenance and wiring tasks. A critical factor to guarantee the right operation of the operator terminal is ventilation. The operator must provide adequate space within the enclosure and consider other equipment in these considerations. The operator may easily use the HMI using its touch screen interface.

2711C-T6C is a PanelView Component C600 terminal by Allen-Bradley. For low-level applications with a serial connection, this component-level operator interface provides a control and visualization solution. Web application creates Human-Machine Interface (HMI) applications while your computer is connected directly to the terminal. The direct result shows on the terminal display without having to download it first. It has a size of 8.23 x 6.0 inches with an active display area of 4.53 x 3.39 inches. It has 5.7 inches Color transmissive STN active-matrix LCD with a resolution of 320 x 240 pixels. It comes with an analog touch for input with an actuation rate of 1 million presses, and a non-replaceable cold cathode fluorescent lamp (CCFL) backlight with a minimum of 50,000 hours of life. It has an input voltage range from 18VDC to 30VDC with a nominal value of 24VDC, maximum power consumption of 10 watts, and heat dissipation of 32 British thermal units(BTU) per hour. It has an Ethernet port that supports a connection to a computer for application and design communication to a controller. It has a multipurpose RS-232 port which supports DF1 full-duplex communication with controllers using direct/modem connection, and DH-485 communication through a serial connection. Preferred controllers are MicroLogix, SLC, and Micro800. It also has an RS-485 port that supports point-to-point communication, a USB device port for maintenance or programming only, and a USB host port to power USB peripherals. It is connected to a browser using a USB port. Install the Allen-Bradley PanelView USB remote NDIS Network Device driver before connecting your computer to the USB port of the 2711C-T6C. It has internal storage, a USB flash drive, and an SD card for memory options.